Odd question but gonna ask it anyway

[Cossie1]

I have a 60mm Greddy boost gauge that I want to fit to my evo 6.

However I can't find any pillar pods that I like the look of, so Have decided that it would look ok in the largest of the 2 centre air vents in the car (1 closest to the driver).

Anyway, does anyone know how to remove this vent (without breaking it) so I can put my gauge there.

Any help would be great.

Thanks

Not sure about the vent , but this was where my boost gauge was fitted.


And when sitting in the seat you could still see the speedo ok.

Just following the Bazza size picture

[Cossie1]

nice boost gauge (and nice photoshop of the speedo )

But I don't fancy having my boost gauge there, will distract me from looking at the rev counter (no point in looking at the speedo unless the old bill are about )

Originally Posted by cossie1

nice boost gauge (and nice photoshop of the speedo )

But I don't fancy having my boost gauge there, will distract me from looking at the rev counter (no point in looking at the speedo unless the old bill are about )

I did that speedo thing as a joke to my mate who has a scooby, as he sent me a pic on his mobile of him doing 145mph.
So I fiddled with that pic , printed it out and took a close up pic of it with my mobile and sent it to him.
He rang me up saying Fu*kin hell didnt think they went that fast

[RSE MOTORSPORT]

I can get you a single "A" Pillar pod, direct replacement panel

give me a shout if you are interested

Tina. x

[Cossie1]

IM SHOUTING

[RSE MOTORSPORT]

YHPM babes :muhaha: shouting back

[Cossie1]

and replied

[Cossie1]

so then, does anyone know how to remove the vent ? as I can use this in the meantime and replace it when / if I do see a pod I like