|
|
| Register | FAQ | Members List | Calendar | Mark Forums Read |
|
#1
03-10-2006, 06:15 PM
|
|||
|
|||
|
manual valve
ive have just bought a forge manual boost controller..
i no this i not a good thing to do.. but im going to elvington drag way this weekend and wanted to see if i can improve my time.. am only going to turn up to 1 bar.. as im only running 0.8 bar.. and was last time i run.. now the important part :muhaha: i just wondered if anybody on here as owned one and have they had any problems with this make... before i fit it.... thanks...
__________________
fully forged bannana running 373bhp 346 torque at 1.26 bar.. 
|
|
#3
03-10-2006, 07:11 PM
|
|||
|
|||
|
Quote:
cheers craig will be down in morning.... i got it from larkspeed later today..
__________________
fully forged bannana running 373bhp 346 torque at 1.26 bar..
|
|
#4
03-10-2006, 07:15 PM
|
|||
|
|||
|
they fine mate. had one on mine for about 18 months now. have a greddy profec II to fit sometime soon just because i want it in the car. are you going sunday pal? might pop along.
|
|
#5
03-10-2006, 07:23 PM
|
|||
|
|||
|
Quote:
think a couple of members are also calling down..
__________________
fully forged bannana running 373bhp 346 torque at 1.26 bar..
|
|
#6
03-11-2006, 08:38 PM
|
|||
|
|||
|
well i have fitted it today and whow what a diffrance... boost comes in alot quiker and stronger..
it pulls like a trooper through all gears.... drove home on the motorway from craigs garage to see if was set right to hold 1 bar in 3rd , 4th etc..all ok.. . so when come to a clear run on the motorway.. i put my foot down to see the diffance.. and she pulled too 150mph no problem and was still going but thought i'ld better stop... just need to fit the new turbo elbow and down pipe now to see the change again if any.... the real test will come tomo on the race way.. as im hopin to bet my best time of 12.6...
__________________
fully forged bannana running 373bhp 346 torque at 1.26 bar..
|
|
#7
03-11-2006, 09:59 PM
|
|||
|
|||
|
what you got a standard downpipe at the mo? If you got a 12.6 at 0.8bar you were doing well mate!
|
|
#8
03-12-2006, 08:14 AM
|
|||
|
|||
|
the evo 3 is booked too do the 1/4 mile in 12.8 seconds standard.. according to the mitsubishi lancer story book anyway will put up pics of page when i get back...
__________________
fully forged bannana running 373bhp 346 torque at 1.26 bar..
|
|
#9
03-12-2006, 04:53 PM
|
|||
|
|||
|
mind they do seem to get good times matey. The low ratio box helps. 12.6 is a crackin time though. reckon i should be in low 12s.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
