|
|
| Register | FAQ | Members List | Calendar | Mark Forums Read |
|
#1
08-01-2005, 08:32 PM
|
|||
|
|||
|
apexi avc-r (help needed!)
just had a go at fitting the avc-r to my evo 6 and its a bit of a puzzle
 in the manual it seems to be a little diffrent to the actual engine bay! does the 2 pipes comming out of the actuator connect to the avc-r solenoid valve? do you block the existing 2 pipes comming out of the original solenoid valve(and with what?) also does the original solenoid valve need disconnecting? as well as blocking the air box pipe where 1 of the above boost pipes went to? i connected the pressure sensor to the pipe that goes to the dump valve (wasnt sure about the 2 pipes that connect to some sort of adjustable sensor near the fuel rail) is this correct?? and the last thing thats posing a problem is are there any grommets tom run the electrical cables through to the cockpit and if not where is the best place to drill as its a little crowded in there  ANY HELP WOULD BE APPRECIATED :woohoo: 
|
|
#2
08-01-2005, 08:50 PM
|
|||
|
|||
|
If you can wait till morning Lee hun Andy or Paul will call you and tell you how to sort it babes
 Send me your number via PM Tina. xx
__________________
Life's not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece, but instead, to skid across the line broadside, thoroughly used up, worn out, leaking oil shouting " GERONIMO " :muhaha:
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
