|
|
| Register | FAQ | Members List | Calendar | Mark Forums Read |
|
#1
08-24-2006, 09:21 AM
|
|||
|
|||
|
fitting a magnus type intake to my evo 8
I have purchased a new intake manifold for my evo 8...
Is there any need to keep the 3 little pipes that go to the throttle bodie as they are used for the over boost swith and another valve bolted below the throttle bodie,Can i ditch this as the new manifold has no flange for the valve... Sorry if im a bit bad at explaining,I understand what i mean but if you need pictures i can post some... 
|
|
#2
08-25-2006, 08:21 PM
|
|||
|
|||
|
The 3 pipes go to the top of the throttle bodie and have P,E & A on the casting,These go down to a valve which i assume is boost cut...
Any ideas... Would i also have a problem using a T piece to put the pipe from the back left of the rocker (near filler cap) into the brake servo vacumn line and then to my manifold... Any help would be appreciated as im a little stuck now :helpme:
|
|
#3
08-29-2006, 07:22 PM
|
|||
|
|||
|
BTTT
Help please......
|
|
#5
08-30-2006, 11:56 AM
|
|||
|
|||
|
No mate my car hasnt got that...Autofixed noticed it when i took it there
|
|
#7
08-30-2006, 03:37 PM
|
|||
|
|||
|
This is a link to the picture of the pipework and valve that goes to the P,E & A on the throttle bodie
http://www.lancer-evo.net/community/...hp?pic_id=5297 Heres where the 3 pipes go to http://www.lancer-evo.net/community/...hp?pic_id=5298 What does this pipe do from the cam cover (pic below) I know it goes to the inlet manifold but whats its purpose http://www.lancer-evo.net/community/...hp?pic_id=5301
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
