Lancer Evo Forums


Go Back   Lancer Evo Forums > Evo Autos Information > Automotive Chat > Automotive Archives

Reply
 
Thread Tools Display Modes
  #1  
Old 09-10-2005, 10:22 PM
Guest
 
Posts: n/a
CP9A 1998 Evolution V

Visitors to the 1997 Tokyo Show got a sneak preview of the Lancer Evolution V. Although it still had 276bhp, there was a substantial increase in torque output, and it's attractive 17" aluminium alloy wheels concealed powerful Brembo brakes. Press material handed out at the event said that it would be available in the spring, wetting the appetite of Motorsport enthusiasts everywhere. Ultimately announced on 6 January 1998, sales began three weeks later.

The aluminium bonnet design was revised for better heat dissipation, and the same lightweight material was adopted for the flared front wings [the rear # fender size was increased via wheel arch blisters]. There were new front and rear bumpers, a different airdam, modified side and rear skirts, a four-position rear spoiler with a delta shaped wicker and aluminium wing.

As for the leading dimensions, while the height [1415mm] and wheelbase [2510mm] remained the same as the Evolution IV, the length was now 4350mm, which was an increase of 20mm and the width was increased by 80mm, taking it to 1770mm overall. The track measurements were also wider at 1510mm at the front and 1505mm at the back. The bigger car followed the trend started by the World Rally Car regulations, although the Evolution V still managed to just keep within the Group A regulations.

The engine was basically the same, with 8.8:1 compression ratio retained. However, there was a modified twin-scroll turbocharger [TD05HR-16G6-10.5T] and intercooler, new lightweight pistons, and the radiator and oil cooler capacities were increased. Torque was enhanced somewhat by these changes over the Evolution IV - now listed at 275lb/ft at 3000rpm.

Gear ratios were carried over from the Evolution IV [including the options on RS], but the synchromesh and swift linkage was made stronger, topped with a smaller gearknob trimmed in black leather with red stitching [actually, a number of road tests mentioned the better gearshift]. The innovative AYC system continued on the GSR, matched with a helical LSD up front. There was a longer lower arm on the front suspension, made from forged aluminium alloy, and the inverted front struts were given longer strokes. Mountings were changed at the rear to give the car its wider track, while revising the geometry at the back end gave a lower roll centre, thus enhancing road holding and vehicle response during cornering.

In addition, the steering rack location was altered, along with the knuckle joint location, in order to give more linear response in corners, while a new pump was adopted, allowing the engineers to remove the power steering oil cooler to save weight.

Tyres were now 225/45 ZR17 on OZ alloys - although 7.5J x 17, they were nonetheless of similar design to those fitted on the Evolution IV. As a a result, the front gained four-pot calipers [formerly 2-pot] and bigger 320mm diameter discs, while two-pot calipers were employed at the rear, again with larger 300mm diameter discs. Brakes were made by Brembo, with ABS coming as standard on the GSR. Inside, the Recaro bucket seats were employed, the Momo leather-trimmed steering wheel was carried over, as were the white faced gauges. Dual airbags were again a part of the GSR package. Carrying the CP9A-SNGF code the GSR was priced at 3,248,000 Yen.

The interior was trimmed in black with grey inserts. The basic RS model carried the CP9A-SNDF code, it was available at 2,598,000 Yen. Still, running on 15" wheels and tyres, it required the old braking system. Tyres were now 225/45 ZR17 on OZ alloys [OZ Racing F1 Cup]. It weighed in at 1260kg, instead of the 1360kg for the GSR, although weight could be reduced further on the RS by opting for the thinner gauge body, or by asking for a car minus the aerodynamic appendages. RS packages were basically the same, although the optional wheel and tyre combinations were naturally bigger, in line with the standard GSR fitment, and a crossmember support bar was added each time the larger wheels and tyres were specified. Dealer options included red "Ralliart" or dark silver "Evolution V" mudflaps, a turbo boost gauge, centre console kneepads, front and rear strut bars, an uprated suspension kit, a sports exhaust, navigation system, and various badges.
Reply With Quote
  #2  
Old 10-02-2007, 01:53 PM
evo5 evo5 is offline
Member
 
Join Date: Mar 2007
Posts: 30
Evo 5

Hi i would just like to say thanks to all the staff at wallice performance in aberdeen they got 376 bhp from my car and it is going good i real think they are the dogs
if you need more power :-)
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 04:55 AM.


Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.